Zoner Photo Studio 1.1
Goto page Previous 1, 2 |
|
Author |
Message |
DickExpert Member
Posts: 5780 Joined: 21 Sep 2006 Location: Rialto, CA.
|
|
Posted: Sun May 03, 2009 4:26 pm |
|
|
Coop, I tried the step-by-step, and no problems! I used the OBV, and made a check of the die(s). Exact fit. Then flipped, and rotated the REV. Slid it over, and made an overlay. What I had to do in the resizing, was to change the numbers, but no problem A bit of interpolation, and home free! Later, I am, going to make a solid copy of the '55-D, I was asking about, and compare it with all the listed dies, (again), then look around for a photo of the 1955D-1MM-005. Then I will check it with mine. If that doesn't ID the die, then it will go to Bob, for checking, and attribution. That way we will have a photo of the -005, or it will be a new one! Either way, we benefit! Once I get this down to the point that I can lay in bed, and mentally make an overlay, then I'll feel more confident! Then there will be rtime to see what all the other little buttons, etc, are for! Thanks for your generosity, and time!
Dick
_________________ " Deja Moo: The feeling that you've heard this bull before".
|
|
|
|
|
|
coopExpert Member
Posts: 3402 Joined: 17 Sep 2003 Location: Arizona
|
|
Posted: Sun May 03, 2009 9:32 pm |
|
|
WOW! Another satisfied customer. Now I bet everyone else wonder what I told him?
_________________ Richard S. Cooper
You may be only one person in the world, but you may also be the world to one person.
|
|
|
|
|
|
DickExpert Member
Posts: 5780 Joined: 21 Sep 2006 Location: Rialto, CA.
|
|
Posted: Sun May 03, 2009 10:57 pm |
|
|
Coop, you might check the RPM?, in this section.
Maybe that will give them a hint.
Dick
_________________ " Deja Moo: The feeling that you've heard this bull before".
|
|
|
|
|
|
|
|